DA20060

20060 Conversion Kit

Used to convert any Danuser PTO Digger with a 622 casting number over to the 273 pinion. This kit includes a pinion, Pinion Guard, and all parts out through the center cross at the U-Joint on the gearbox, and a 7270 Auger Adapter Guard for 2-3/8″ diameter center column augers. This kit required on all diggers with serial numbers ranging from 60,001 to 71,199.

SERIAL NUMBER 60,001-71,199

# 20060 Conversion Kit

• Pinion with hardware
• Input Guard
• Gaskets
• Grease Seals
• Driveline End Yoke and Center Cross Repair Kit (Gearbox End)
• Auger Adapter Guard
• SMV (slow moving vehicle) Kit with hardware
• Operator’s Manual canister with hardware

NOTE: welding will be required.

>If the serial number of your F-Series PTO Digger is 60,001 to 71,199 and the unit has not been converted to the # 7562 Pinion Assembly, you need to purchase a # 20060 Conversion Kit. The # 20060 Conversion Kit includes a pinion with hardware, Input Guard, gaskets, grease seals, all driveline parts out through the center cross at the U-Joint on the gearbox, and an Auger Adapter Guard. This # 20060 kit is required on all diggers with serial numbers ranging from 60,001 to 71,199.

>If your serial number plate is missing or unreadable, the conversion kit you need applies to the style of PTO you are using today.

• If you have an unguarded PTO shaft, yellow metal or black metal, and your PTO is connected to the pinion with a castle nut, you will need Conversion Kit # 20050.
• If you have an E-clip style PTO where the PTO connects to the pinion with an E-clip (horseshoe looking clip), you will need Conversion Kit # 20060.

These conversion kits are sold direct at NET PRICE plus shipping.

______________________________________________________________________________________________________________________________________________________________________________________________________

PRICE DOES NOT INCLUDE SETUP OR SHIPPING – PRICED FOB FACTORY