Westfield Tailgate / Drill-Fill Auger | Steel Flighting | 8-12 GPM @ 1400 PSI
Price Does Not Include Setup Or Shipping – F.O.B. Factory
Westfield Drill-Fill / Truck Auger
- Rear mount 6″ x 15-1/2′ fold down drill fill with One-Pin mount system for quick on/off
- Spring assisted lift with ground level lever for transport/operate positioning
- 4.5 cubic inch hydraulic motor with 12 volt electric solenoid control valve
- 14-1/2′ telescoping spout with on/off switch
- Clean out door with cam lock
- Large opening in hopper for quick dumping of grain
- Mounting brackets
Note: Requires a minimum of 8.0 GPM at 1400 PSI (Maximum of 12.0 GPM)
Westfield Rear Mount Drill Fill Augers | Designed For Easier Bulk Handling
It’s on or off in a jiffy with one single mounting pin. You don’t even need a wrench. The long 6″ by 15½’ auger allows full tarping of the load. And there’s a convenient remote on-off control on the 14½” telescoping downspout. The 4.2 cu. in. hydraulic motor with standard 12 volt solenoid control is located at the bottom of the auger requiring minimum plumbing.
Poly Cupped Flight
• Injection molded for consistent quality – each module is assembled onto a stainless steel or mild steel center tube.
• Interlocking lap joint (patented) – produces a substantially smooth, strong, and continuous surface.
• Strong, abrasion-resistant flighting.
The Lundell Corporation has combined the proven gentleness and durability of high density polyethylene with the cupped design in auger flighting. Injection molded for consistent quality, each poly-flight module is assembled onto a mild steel or stainless steel hexagon tube. The modules fasten together using a patented interlocking lap joint. This feature produces a strong, smooth, continuous surface that has proven itself through years of conveying grain, dry fertilizer, blasting shot, salt, and many other materials.
Soybean Crack Test Results * | ||
---|---|---|
Flighting Type | Percent Breakage | Average Breakage |
Plastic Cup | 0.38% | 38 |
Bristle | 0.35% | 35 |
Steel | 1.80% | 180 |
Steel Cup | 2.10% | 210 |
Average breakage based on per 10,000 beans. Test ran with hydraulic motor at 12 gal/min (6” x 13’ uni-swivel auger at a 45° angle). Average moisture content of the bean seed samples was 12%. |
Weight | 215 lbs |
---|